Electrical Safety - Beurer monogram Instructions Manual

Safety
Your heated underblanket has been designed and fully tested to
the European Safety Standards.
It has been certified by the Intertek Testing and Certification Ltd. UK and shows
the safety mark "BEAB Approved".
Your heated underblanket is safe and can be used all night (setting "1").
An electronic sensor mechanism in your heated underblanket protects it from over-
heating by switching it off automatically if it is faulty.
The safety system constantly monitors the temperature of the heated underblan-
ket. If the heated underblanket reaches a temperature that could be dangerous,
the system will turn off the heated underblanket.
Once the safety system has turned off the heated underblanket, the controller will
no longer work and you can not reset it. You must return it, with the heated under-
blanket, to our service department. The address is on the last page of this leaflet.
Although your heated underblanket has this safety system, you must still follow
these instructions.

Electrical safety

Your heated underblanket has a UK plug. If your heated underblanket becomes
damaged or worn, you should have the plug top replaced by a qualified electrician
who understands how to carry out this repair safely.
The plug needs a 3-amp fuse (BS1362 rated).
Before you switch on your heated underblanket for the first time, please check the
voltage on the heated underblanket label is the same as the voltage in your home.
Fitting your heated underblanket
Putting into operation
We recommend that you vacuum off your mattress before us-
ing the heated underblanket for the first time. Then spread out
the heated underblanket flat on your mattress so that the cable
entrance is located approximately at shoulder height (see illus-
tration). The head area of the heated underblanket is not heat-
ed. Then pull the side section over the sides of your mattress
like a contour sheet.
5