Beurer monogram Instructions Manual page 6

Then secure your contour sheet as accustomed so that the heated underblanket
is between your mattress and the contour sheet.
Make sure that the heated underblanket is always spread out flat and does not
push together or wrinkle during use. Check its position when making the bed.
The heated underblanket may only be switched on when it is spread out flat. We
recommend switching on the heated underblanket approx. 8 minutes before go-
ing to bed and covering it with the duvet in order to prevent heat loss. First select
the highest temperature setting (level 6). This produces the fastest warming. This
heated underblanket may only be operated in conjunction with the switch type
specified on the unit.
Attention: The electronic components in the controller will normally warm up
slightly when the product is being used. The controller should not lie on or
be covered by blankets, pillows etc.
Connecting your heated underblanket
All of our heated underblankets are connected to a
controller with a plug and socket, which must be in-
serted fully before use.
If you have a dual control underblanket there will be
two controllers. You need to plug both of them in.
Dual control means that you can control each half of
the heated underblanket separately.
When removing the plug from the socket, it is important that you do not use the
cable to pull them apart.
6