Part Names And Functions - Denon DP-DJ151 Operating Instructions Manual

ENGLISH
(3) Mounting the cartridge
• The cartridge is not included.
Mount your cartridge on the head shell.
• The head shell's lead wires are color-coded. Use
tweezers or the like to securely connect the lead wires
to the corresponding terminals on the cartridge,
referring to the indications on the cartridge or the
cartridge's instructions.
Attach wires as follows:
White (L +) Left channel +
Blue (L –) Left channel –
Red (R +) Right channel +
Green (R –) Right channel –
• The proper overhang is achieved by mounting the
1
cartridge so that the stylus is positioned 53 mm from
the head shell mount edge (rubber washer), as shown
on the diagram below.
Insert the head shell on which the cartridge has been
2
mounted into the tone arm and fasten it in place
using the lock nut.

2 PART NAMES AND FUNCTIONS

Top panel
@2
@2
SLOW
BRAKE
q
OFF ON
POWER
w
START
78
/STOP
33 45
e
6
53 mm
@1 @0 !9
KEY ADJUST
-12
Quartz
0
+12
DP-DJ151
r t
y u i
q
Power dial (POWER)
ON – Rotate right
OFF – Rotate left
w
Start/Stop button (START/STOP)
• Press this button to start and stop the platter rotation.
e
Platter revolution speed buttons
33 rpm – Press 33
45 rpm – Press 45
78 rpm – Press 33 and 45
r
Strobe dots
• Four rows of dots that indicate various stages in pitch adjust.
– 3.3 % – outer row
– 3.0 % – large dots
+ 3.3 % – next row
+ 7.2 % – inner row
t
Brake switching button (BRAKE)
• The platter stops turning.
• When the BRAKE button's LED is lit, rotation stops slowly (in
about 2 seconds).
• When the BRAKE button is flashing, internal electronic brake
is set free.
y
Target light
• Press the button to the right and a light will pop up directed
at the stylus position.
u
Headshell
Attach the cartridge here.
• When installing a cartridge, refer to the installation
instructions supplied by the manufacturer of that cartridge.
During installation, attach the stylus protector to guard the
stylus tip from damage.
i
Headshell locking nut
• Attach headshell by inserting into the front end of the tone
arm, then turn the locking nut clockwise with the head shell
firmly held horizontally.
o
Pitch slider
• Use this to change the speed of the platter when the PITCH
button is lit. You can adjust the speed in a range of ±12 %.
!8
!0
S-shaped tone arm
!7
!1
Pitch button (PITCH)
!6
ON – Will allow use of the pitch adjust.
OFF – Will hold the revolution speed at exactly the specified
!5
speed.
!4
!2
Key adjust button (KEY-ADJUST)
!3
NOTE: The "KEY ADJUST" function effective only operate
!1
PITCH
while the "PITCH" button is lit on.
!3
!2 Tone arm clamp and rest
• Use this rest the tone arm and clamp it in position during
!0
transportation.
o
!4
Lifter lever
• Use this to lift and lower the tone arm.
!5
Anti-skating knob (ANTI-SKATING)
Digital
• When a record is playing, a force is generated drawing the
stylus towards the center of the record. Set this knob to the
same value as the stylus pressure to offset this force.
!6
Tone arm height adjust (HEIGHT ADJUST)
• This allows the tone arm to be properly align with the platter
surface.
!7
Height lock lever (LOCK)
• Prevents accidental adjustment of the height.