Advertisement
ENGLISH
(3) Mounting the cartridge
• The cartridge is not included.
Mount your cartridge on the head shell.
• The head shell's lead wires are color-coded. Use
tweezers or the like to securely connect the lead wires
to the corresponding terminals on the cartridge,
referring to the indications on the cartridge or the
cartridge's instructions.
• The proper overhang is achieved by mounting the
cartridge so that the stylus is positioned 53 mm from
the head shell mount edge (rubber washer), as shown
1
on the diagram below.
Insert the head shell on which the cartridge has been
2
mounted into the tone arm and fasten it in place
using the lock nut.
2 PART NAMES AND FUNCTIONS
Top panel
@1
@2
SLOW
BRAKE
q
OFF
ON
POWER
w
START
78
/STOP
33
45
e
6
53 mm
@0
!9
!8
-12
Quartz
0
+12
r t
u i
y
q
Power dial (POWER)
ON – Rotate right
OFF – Rotate left
w
Start/Stop button (START/STOP)
• Press this button to start and stop the platter rotation.
e
Platter revolution speed buttons
33 rpm – Press 33
45 rpm – Press 45
78 rpm – Press 33 and 45
r
Strobe dots
• Four rows of dots that indicate various stages in pitch adjust.
– 3.3 % – outer row
–
3.0 % – large dots
+ 3.3 % – next row
+ 7.2 % – inner row
t
Brake switching button (SLOW BRAKE)
• When this button is pressed and the LED is lit, the slow
brake function turns on, setting the stopping time from
normal rotation and the time from the stop mode until the
normal rotation speed is reached to approximately 2
seconds.
y
Target light
• Press the button to the right and a light will pop up directed
at the stylus position.
u
Headshell
Attach the cartridge here.
• When installing a cartridge, refer to the installation
instructions supplied by the manufacturer of that cartridge.
During installation, attach the stylus protector to guard the
stylus tip from damage.
Attach wires as follows:
White (L +) Left channel +
Blue (L –) Left channel –
!7
Red (R +) Right channel +
Green (R –) Right channel –
!6
i
Headshell locking nut
!5
• Attach headshell by inserting into the front end of the tone
!4
arm, then turn the locking nut clockwise with the head shell
firmly held horizontally.
!3
o
Pitch slider
!2
• Use this to change the speed of the platter when the pitch
!1
ON button's LED is lit. You can adjust the revolutions in a
range of ±12 %.
!0
!0
S-shaped tone arm
o
!1
Pitch ON/OFF buttons (PITCH)
ON – Will allow use of the pitch adjust.
OFF – Will hold the revolution speed at exactly the specified
speed.
!2
Tone arm clamp and rest
• Use this rest the tone arm and clamp it in position during
transportation.
!3
Lifter lever
• Use this to lift and lower the tone arm.
!4
Anti-skating knob (ANTI-SKATING)
• When a record is playing, a force is generated drawing the
stylus towards the center of the record. Set this knob to the
same value as the stylus pressure to offset this force.
Advertisement
