Bench Mounting; Assembly - Grizzly T25920 Owner's Manual

Bench Mounting

Number of Mounting Holes ............................ 4
Diameter of Mounting Hardware Needed ..
The base of this machine has mounting holes
that allow it to be fastened to a workbench or
other mounting surface to prevent it from moving
during operation and causing accidental injury or
damage.
The strongest mounting option is a "Through
Mount" (see example below) where holes are
drilled all the way through the workbench—and
hex bolts, washers, and hex nuts are used to
secure the machine in place.
Machine Base
Workbench
Figure 10. "Through Mount" setup.
Another option is a "Direct Mount" (see example
below) where the machine is secured directly to
the workbench with lag screws and washers.
Machine Base
Workbench
Figure 11. "Direct Mount" setup.
-14-
⁄ "
1
4
Hex
Bolt
Flat Washer
Flat Washer
Lock Washer
Hex Nut
Lag Screw
Flat Washer

Assembly

Assembly consists of installing the electrical box
and tailstock handwheel handle.
Note: If not mounting machine directly to a work-
bench, install the four included rubber feet (see
Figure 12). Adjust feet until lathe sits level, with-
out rocking.
To assemble machine:
1.
Mount electrical box to lathe with two pre-
installed Phillips head screws and flat wash-
ers (see Figure 12).
Electrical Box
Rubber Feet
(1 of 4)
Figure 12. Rubber feet and electrical box
installed.
2. Use flathead screwdriver to install handwheel
handle into tailstock
Figure 13).
Figure 13. Tailstock handwheel handle installed.
Model T25920/T25926 (Mfd. Since 08/14)
x2
handwheel (see
Tailstock
Handwheel
Handwheel
Handle