securio P 44 Operating Instructions Manual page 17

http://www.monomachines.com/
Fault and function indicators
Display Problem
Paper jam
Overload
Continu-
ous lamp
Flashing
Paper and
light
CD fed at
the same
time
Press safety
element
Paper/
shredded
material
Continu-
container
ous lamp full
CD contain-
Flashing
er full
light
Door is
open or
safety
element not
latched
Metal detec-
tion
09/2015
http://www.monomachines.com/
Measure
You have fed in too much paper.
 The cutting unit runs in reverse for a few seconds and pushes the paper
back out again.
• If necessary, press the reverse button "R" to remove the stack of paper.
• Take half the stack of paper.
• Feed the paper in portions.
Note
You can lift up the safety element in order to better remove paper. To do
this, press the middle section of the front of the safety element and lift up
the fl ap.
Note
This indicator lamp also lights up when the motor is overloaded. In this
case, let the shredder cool down for 20 minutes before using it again.
• Do not use both cutting units at the same time, but rather shred paper and
CDs/diskettes/credit cards separately.
• The LED also fl ashes if you press the safety element or open the door while
there is a paper jam.
• Empty the paper/shredded material container.
Note
If you press the reverse button briefl y before opening the door, part of the
material is pulled back into the cutting apparatus.
• Empty the CD container. To do so, lift it upwards out of the bracket.
• Close the door or latch in the safety element.
Note
Movement of the safety element was detected during the shredding proce-
dure. If your machine switches off without signalling an error, pull the paper
out of the paper slit and feed it back in again.
• Press the reverse button and pull the paper put of the feed slot.
• Remove any metal which is in the paper or on the safety element.
• Acknowledge the error by pressing the R button.
SECURIO P 44
english
For More Info
Click Here --->
17