Philips Baby Monitor SCD463 User Manual page 8

Getting your baby monitor ready
EN
Using your baby monitor
8
Battery operated use
1 Remove the battery compartment cover (B-10) of the parent
unit, by sliding down the cover.
2 Insert four 1,5V AA batteries, noting the + and –
configuration inside the battery compartment (batteries are
not supplied, we recommend Philips Alkaline batteries)
3 Slide the battery compartment cover (B-10) back in place
until it clicks in position
The parent unit is now ready for battery operated
use.
1 Position both units in the same room to test the connection.
Make sure the baby unit is at least 1 meter / 3 feet away from
the parent unit.
2 Press the ON/OFF button (A-1) to switch on the baby unit.
> The POWER light (A-6) lights up green.
3 Switch on the parent unit using the ON/OFF switch (B-8) and
adjust the volume to the level you prefer using the VOLUME
control (B-8).
> The POWER light (B-9) lights up green.
> When connection has been established between the units,
the LINK light (B-2) on the parent unit lights up green.