Philips SC1992 User Manual page 24

Hide thumbs Also See for SC1992:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
ENGLISH
24
Problem
The hair-removal
results are not
satisfactory.
Hair starts to
grow again in
some spots on the
treated areas.
The appliance
does not work.
Possible cause
Solution
You have used a
Perform a skin test to determine if you can use a higher light
light intensity that
intensity (see chapter 'Using the appliance', section 'First use
is too low for you.
and skin test'.
You did not make
For proper hair-removal results, you have to make overlaps
enough overlaps
when you use the appliance. See chapter 'Using the appliance',
when you used
section 'Subsequent use', step 4.
the appliance.
You do not use
To remove all hairs successfully and to prevent the hair
the appliance
root from becoming active again, the treatments have to be
as often as
repeated once every two weeks for the first two months.
recommended.
To ensure that your skin stays smooth, we advise you to repeat
the treatment every four to six weeks. The time between
treatments may vary based on your individual hair regrowth
and also across different body areas. If too many hairs grow
back between treatments, simply shorten the treatment
interval again, but do not treat any area more often than once
every two weeks. When you use the appliance more frequently
than recommended, you do not increase the effectiveness but
you do increase the risk of skin reactions.
You respond
Continue using the appliance for at least 6 months, as hair
more slowly to IPL
regrowth can still decrease over the course of this period.
treatment than the
Also take into account the other solutions to this problem.
average user.
The appliance is
Do not use the appliance if your body hair is light blond, red,
not suitable for
grey or white. Do not use the appliance either if you have
your hair or skin
dark skin. Consult the body hair and skin colour table in the
colour.
Quick Start Guide.
You did not make
For proper hair-removal results, you have to make overlaps
enough overlaps
when you use the appliance. See chapter 'Using the appliance',
when you used
section 'Subsequent use', step 4.
the appliance.
Hair starts to grow
This is normal. It is part of the natural cycle of hair growth
again as part of
that hair starts growing again. The hairs that come back,
the natural cycle of
however, tend to be softer and thinner.
hair growth.
The appliance is
Contact the Consumer Care Centre in your country, your
defective.
Philips dealer or a Philips service centre.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sc1991

Table of Contents