How To Achieve Optimal Results - Philips SC1992 User Manual

ENGLISH
16
Subsequent use
1 Before every treatment, clean the body attachment, the light exit
window and the metallic frame inside the body attachment. For more
information see chapter 'Cleaning and maintenance'.
2 Start each treatment by selecting the light intensity very carefully,
based on your skin's sensitivity and on how comfortable treatment
feels. See section 'Recommended light intensities' to select the right
setting for your skin type and hair colour combination.
Note: Your skin may react differently on different days/occasions for a number
of reasons. See section 'Possible side effects and skin reactions' in this chapter
for more information.
3 Follow steps 2-6 of the previous section ('Before first use and skin test').
Note: It is normal that the appliance and the body attachment become warm
during use.
4 Slide the appliance over the skin to the next area to be treated
and repeat steps 5 and 6 of section 'First use and skin test' in this
chapter. After each flash, it takes up to 3.5 seconds until the appliance
is ready to flash again. The 'ready to flash' light on the back of the
appliance starts blinking again to indicate that it is charging. Wait until
this light lights up continuously before you continue.
Tip for SC1992: The SC1992 has a 'slide and flash' feature: for a more efficient
treatment, keep the flash button pressed while you slide the appliance over
your skin.
Do not treat exactly the same area multiple times during one session.
This does not improve the effectiveness of the treatment, but increases
the risk of skin reactions.
5 To avoid untreated areas, make sure the flashes are produced close
to each other. Note that effective light only comes out of the light
exit window. However, always make sure you do not flash the same
area twice.
6 When you have finished the treatment, press and hold the on/off
button for 2 seconds to switch off the appliance.
7 Check the light exit window and the body attachment for hairs and
dirt and clean the appliance after use (see chapter 'Cleaning and
maintenance').
Tips

How to achieve optimal results

- It is normal that hairs are still visible after the first few treatments (see
chapter 'Introduction', section 'Working principle' for more information).
- To remove all hairs successfully and prevent the hair follicle from
becoming active again, the treatments have to be repeated once every
two weeks for the first two months. Your skin should be smooth and
hair-free by then. Please read section 'Maintenance phase' to find out
how you can keep these results.