Deluxe Control Identification; Deluxe Control Set-Up - Alto-Shaam 300-s Installation Operation & Maintenance

power on indicator light
on
upper
lower
Double
Compartment
Control
on/off Button
Press the On/Off button once and the power
indicator light will illuminate. Press and hold
the On/Off button until the LED display
turns off (at least three seconds) and power
indicator light goes out.
Up/Down arrows
The Up or Down arrows are used for a
variety of settings when selecting the holding
temperature. If an arrow button is pressed
and released the display will show the current
set temperature for four seconds. If an arrow
button is held (at least eight seconds), the
value will change at a rapid rate. Pressing
an arrow button when the set temperature
is displayed will increase/decrease the
temperature by 1°. Pressing and holding
an arrow button will increase/decrease the
temperature by 10°.
enable / Disable Beeper
A beeper sounds when an error code is
displayed. To choose between beeper on
and beeper off mode, the control must be
off, then press and hold the DOwN arrow
until either "ON" or "O f f " is shown
in the LED display. Press either arrow
button to toggle the beeper mode.
o P e r a t I o n
D e l U X e C o n t r o l o P t I o n
/
off
heat indicator
led display
lock indicator
up
arrows
Deluxe Control
D e l U X e C o n t r o l S e t - U P
MN-29423 (Rev . 4) 07/16 • S-Series Hot Food Holding Cabinets • 17
power on indicator light
on
/
down
Fahrenheit/Celsius
with the control off, to choose between
°F/°C Fahrenheit and Celsius, press and hold the UP
arrow until either °F or °C is shown in LED
display. Press either arrow button to toggle
the temperature scale.
The control has a four-digit LED display. when
the display is on, it will show current holding
temperature, as well as diagnostic information.
Control lock
The warmer controls can be locked so that no
changes can be made to the set temperature.
To lock the display, press and hold the
On/Off button and the Up Arrow at the
same time. The lock LED will illuminate.
when the lock LED is illuminated, additional
programming will not be functional other than
the button sequence required to unlock the
panel.
To unlock the display, press and hold the
On/Off button and the Down Arrow at the
same time. The lock LED will extinguish. The
panel buttons will resume normal function.
/
off
heat indicator
led display
lock indicator
with multiple timers
shelf timer keys
I
o
/
up down
arrows