Fitting The Snap-In Sewing Table; Inserting The Needle - Silvercrest SNM 33 B1 Operation And Safety Notes

Installing the snap-in sewing table

Inserting the needle

C
D
A
B
If you want to sew on the arm bed, pull out
the snap-in sewing table (7) in the direction
of the arrow.
The inside of the snap-in sewing table (7)
can be utilised as an accessory box.
Important:
Turn power switch (19) to off ("O").
Change the needles regularly, especially at
the first signs of problems when sewing.
Insert the needle as in the illustration.
A. Loosen the needle clamp screw and
tighten again after inserting the new
needle.
B. The flat side of the shaft should be
towards the back.
C/D. Insert the needle up to the stop at the
end of the shaft.
Only use fully-functional needles:
Problems can occur with the use of:
- Bent needles
- Blunt needles
- Damaged points
Getting ready
GB / IE 33