Pyle PUCVWD43 Instructions Manual page 2

INSTRUCTIONS FOR: WET & DRY SHOP VAC
Thank you for purchasing a product. Manufactured to a high standard this
product will, if used according to these instructions and if properly maintained,
give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE
THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE
FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE
AND/OR PERSONAL INJURY, AND WILL INVALIDATE THE WARRANTY.
PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
1.1 ELECTRICAL SAFETY
It is the responsibility of the owner and the operator to read, understand and
comply with the following:
You must check all electrical products, before use, to ensure that they are safe.
You must inspect power cables, plugs, sockets and any other connectors for
wear or damage. You must ensure that the risk of electric shock is minimised
by the installation of appropriate safety devices. A Residual Current Circuit
Breaker (RCCB) should be incorporated in the main distribution board. We
also recommend that a Residual Current Device (RCD) is used. It is
particularly important to use an RCD with portable products that are plugged
into a supply which is not protected by an RCCB. If in any doubt consult a
qualified electrician.
1.1.1 The Electricity at Work Act 1989 requires that all portable electrical
appliances, if used on business premises, are tested by a qualified electrician,
using a Portable Appliance Tester (PAT), at least once a year.
1.1.2 The Health & Safety at Work Act 1974 makes owners of electrical
appliances responsible for the safe condition of those appliances and the
safety of the appliance operators. If in any doubt about electrical safety,
contact a qualified electrician.
1.1.3 Ensure that the insulation on all cables and on the appliance is safe
before connecting it to the power supply. See 1.1.1. and 1.1.2. and use a
Portable Appliance Tester.
1.1.4 Ensure that cables are always protected against short circuit and
overload.
1.1.5 Regularly inspect power supply cables and plugs for wear or damage
and check all connections to ensure that none are loose.
1.1.6 Important: Ensure that the voltage marked on the appliance matches
the power supply
to be used and that the plug is fitted with the correct fuse.
1.1.7 DO NOT pull or carry the appliance by the power cable.
www.pyleaudio.com