Table of Contents
Advertisement
7.1.6 Ensure that the transparent shampoo delivery tube is fitted correctly
around the suction hose and held in place with the clips provided.
7.1.7 Screw the large threaded connector on the end of the flexible suction
hose to the vacuum inlet on the front of the tank.
7.1.8 Push the connector on the end of the shampoo delivery tube into the
shampoo outlet nozzle on the front of the motor housing.
7.1.9 Slide the spraying trigger fitting into the mount at the top of the plastic
tube. Push gently and ensure it clicks into place.
Fit the large washing head to the plastic tube. Connect the shampoo delivery
tube from the head to the trigger. The black fitting is a push and twist fit.
7.1.10 The spraying nozzle at the other end of the delivery tube is a push fit
into the mounting on the underside of the head. There is a notch in the nozzle
which must fit onto a spigot in the head mounting to ensure that the nozzle
outlet is the right way round.
To clean fabrics and upholstery, clip the spray nozzle with the short tube into
the underside of the small cleaning head. Then attach the trigger directly to the
mounting on the underside of the small head. Push the assembled head onto
the air diffuser handle. Note: The metal plastic tube is not used.
7.1.11 Select the switch to position
, to operate the pump for shampoo
application only.
Select the switch to position
, for simultaneous shampoo application and
dirty liquid suction.
7.1.12 Squeeze the trigger to apply shampoo to the area to be washed.
7.2 CARPET CLEANING
Vacuum the carpet thoroughly before washing it. For best results we
recommend you first remove all furniture from the room to be cleaned, or move
it away from the cleaning area.
Clean the whole carpet systematically in squares of approx. 1.5m each. This
avoids walking over the cleaned carpet until it completely dry.
7.2.1 Start furthest away from the doorway to the room, extend the hose and
work backwards.
7.2.2 Switch to position
, and squeeze the trigger to spray shampoo
into the area to be cleaned.
7.2.3 Squeeze the trigger as you pull the head back towards you, in lengths of
approximately 1.5m. Refill the tank if the fluid spray stops.
7.2.4 Switch off and return to where you started.
7.2.5 Switch to position
to suck up the dirty solution and repeat the
previous pattern of strokes. Apply more shampoo in any particularly dirty area.
www.pyleaudio.com
Advertisement
Table of Contents
