Table of Contents
Advertisement
❚❚ Ending Shooting
To end shooting before all the photos are taken, press J
between frames or immediately after a frame is recorded. A
movie will be created from the frames shot to the point where
shooting ended. Note that if the power source is removed or
disconnected or the destination memory card is ejected, no
movie will be recorded and shooting will end without a beep
being sounded.
❚❚ No Photograph
The camera will skip the current frame if it is unable to focus for
eight seconds or more in AF-S or when single-servo AF is selected
in AF-A or Focus is selected for Custom Setting a1 (AF-C priority
selection) in AF-C (note that the camera focuses again before
each shot). Shooting will resume with the next frame.
D
Time-Lapse Movies
Time-lapse is not available in special effects mode (0 65), during live
view (0 9, 47) or movie recording (0 164), at a shutter speed of A
or & (0 125), or when the self-timer (0 79), bracketing (0 151), High
Dynamic Range (HDR, 0 138), or interval timer photography (0 109)
is active. Note that because shutter speed and the time needed to
record the image to the memory card may vary from shot to shot, the
interval between a shot being recorded and the start of the next shot
may vary. Shooting will not begin if a time-lapse movie can not be
recorded at current settings (for example, if the memory card is full, the
interval or shooting time is zero, or the interval is longer than the
shooting time).
Shooting may end if camera controls are used or settings are changed
or HDMI cable is connected. A movie will be created from the frames
shot to the point where shooting ended.
174 Recording and Viewing Movies
Advertisement
Table of Contents
