Epson EPL-5800 Service Manual page 27

EPSON EPL-5800
Table 1-19. Function Setting (1)
Menu Item
*9
Config Menu RITech
Toner Save
Density
Top Offset
Left Offset
Size Ignore
Auto Cont
Page Protect
Image Optimum
*10
Paper Type
Setup Menu Time out
Standby
Lang
Toner
Toner Out
SelecType Unit
*11
Parallel Menu Parallel I/F
Speed
Bi-D
*11
Buffer Size
*3
USB Menu USB I/F
*11
Buffer Size
Product Description
Value
On, Off
Off, On
3, 4, 5, 1, 2
-99.0 ~ 0.0 ~ 99.0mm
(0.5mm increments)
-99.0 ~ 0.0 ~ 99.0mm
(0.5mm increments)
Off, On
Off, On
Auto, On
Auto, Off, On
Normal, Thick W, Thick N, Trnsprnc
0, 5 ~ 60 ~ 300
Continue, Stop
English, Française, Deutsch, ITALIANO,
ESPANOL, SVENSKA, Dansk, Nederl,
SUOMI, Português
E****F, E***$F, E**$$F, E*$$$F,
E$$$$F
Disable, Enable
0 ~ 99999999
On, Off
Fast, Normal
Nibble, ECP, Off
Normal, Maximum, Minimum
On, Off
Normal, Maximum, Minimum
Table 1-19. Function Setting (1)
Menu
*12
AUX Menu AUX I/F
AUX Config
Buffer Size
NOTE:
*1: This item can be selected only when the optional Adobe PS 3 kit is installed.
*2: Cannot be selected / changed by RCP etc. and is not printed on the Status Sheet.
*3: This item can be selected only when the Type B I/F option is installed.
*4: Displayed only when the optional lower cassette unit is installed. Paper sizes are display
only.
*5: LT= default value for Letter-model controller
A4= default value for A4-model controller
*6: Can be set only with the printer driver. Not printed on Status Sheet. Can be to set with
EJL or PJL, but it is valid only when the installed RAM is 64MB or more. (The firmware
does not verify the installed RAM capacity, but the printer driver does. This must not be
stated in the manual.)
*7: Effective only for ESC/Page, PCLXL and PostScript. When other mode is selected, it will
be printed in 600dpi.
*8: Valid for PCL5e, ESC/Page, ESC/P2, FX and 1239X.
*9: When resolution is set to 1200dpi by mode setting, RITech becomes OFF regardless of
this item.
*10: TBD
*11: When this item is changed, reading with EJL and printing on the Status Sheet are
immediately reflected, but become valid after warm boot or at power on again.
*12: Appears only when the optional Type B interface card is installed.
Network card configurations cannot be made from the printer side. Use the utility that
comes with each card.
*13: Display only when Type B Level 3 card is installed. This value cannot be changed and
always set to "No".
!
Function setting (2)
Control Panel
Item Value
*11
Use, No Use
*13
No, Yes
*11
Normal, Maximum, Minimum
Revision B
29