Vertex Standard EVX-S24 Operating Manual page 39

 Press and hold in the [ SIDE ] key to confi rm the "Call
ID" of the selected message.
 If you want to delete the selected message:
 Press and hold in the [ SIDE ] key again to indicate
the "Delete" selection.
 Press the [  ] / [  ] keys to select the "Yes", then
press the [ MODE (
 You may cancel the deleting the message by select-
ing the "No" instead "Yes" in the above step.
ALL Delete: You may delete the all text messages at once.
 Press the [  ] / [  ] keys to select the "ALL Delete"
selection which is located at the last message loop.
 Press the [  ] / [  ] keys to select the "Yes", then press
the [ MODE ( )] key.
 You may cancel the deleting the all text messages by
selecting the "No" instead "Yes" in the above step.
"SEL MSG" function
In this function, you may send the text message to other
radio.
 Press the [  ] / [  ] keys to select "SEL MSG", then
press the [ MODE ( )] key to accept it.
 Press the [  ] / [  ] keys to select the message you wish
to send.
EVX-S24 O M
PERATING
U S
SER ET
)] key.
ANUAL
( M ) M
ENU ODE
 Press the [ MODE (
appear.
 Press the [ MODE (
keys to select the Contact Alias.
 Press the [ MODE (
sage.
A M
NALOG ODE
Message feature on the "Analog" mode, you may send
the 5-Tone status text of the pre-programmed encoder list,
and confi rm the "Message" corresponding to that received
5-Tone status text.
Sending the Message
 Press the [  ] / [  ] keys to select "SELECT".
 Press the [ MODE (
keys to select the "Message" you wish to send.
 Press the PTT key to send the message.
Confi rm the Message
 Press the [  ] / [  ] keys to select "CHECK".
 Press the [ MODE (
"Message".
)] key, "SEND" notation will
)] key, then press the [  ] / [  ]
)] key again to send the mes-
)] key, then press the [  ] / [  ]
)] key to appear the received
37