Subaru forester 2001 Service Manual page 13

Exhaust
13) Tighten bolts which install the under side of
turbocharger upper cover.
Tightening torque:
7.4 N·m (0.75 kgf-m, 5.4 ft-lb)
14) Install universal joint (RHD model only).
(1) Align bolt hole on the long yoke side of uni-
versal joint with the cutout at the serrated sec-
tion of shaft end, and insert universal joint.
(2) Align bolt hole on the short yoke side of
universal joint with the cutout at the serrated
section of gearbox assembly. Lower universal
joint completely.
(3) Temporarily tighten bolt on the short yoke
side. Raise universal joint to make sure the bolt
is properly passing through the cutout at the
serrated section.
(4) Tighten bolt on the long yoke side, then that
on the short yoke side.
Tightening torque:
24 N·m (2.4 kgf-m, 17.4 ft-lb)
CAUTION:
¼ Make sure that universal joint bolts are tight-
ened through notches in shaft serration.
¼ Excessively large tightening torque of uni-
versal joint bolts may lead to heavy steering
wheel operation.
Standard clearance between gearbox to DOJ:
Over 15 mm (0.59 in)
15) Install under cover.
16) Lower the vehicle.
CENTER EXHAUST PIPE
17) Install intercooler bracket.
18) Install
TURBO)-10, INSTALLATION, Intercooler.>
19) Align center of roll connector. (With airbag
H2M1929
model) <Ref. to AB-11, ROLL CONNECTOR,
INSPECTION, Inspection Locations After a Colli-
sion.>
H2M1950
EX(DOHC TURBO)-12
intercooler. <Ref. to
S2M1928
IN(DOHC