Arturia MatrixBrute User Manual page 49

Loading and saving sequencer Patterns:
• Patterns - You can load and play different sequences, or pattern, by
holding the PATTERNS buttons and choosing from any of the 256
sequences. The banks are rows A - P on the left, and presets within
each bank are in columns 1-16. To load, say, Pattern B3, go two rows
down and three columns across; the B3 red light shows you which
sequence is loaded.
• Link - you can link a sequence to your preset sound. When saving your
preset, enable the LINK button to store them together.
• Save - Just hold this button and select the bank/preset where you want
to save the Pattern. Turn on Link to save a Pattern with a Preset.
Matrix Preset Section [p.37]
• SEQ Length To set the sequence length, i.e. the number of steps up to
64 maximum, hold SEQ Length and touch any of the four buttons in
the last step to be played. They'll light up, and after that the sequence
will cycle back to the beginning when it gets there (assuming you
don't stop it first, and that it's playing forward rather than backward or
random).
5.3.0.1. Step parameters:
The sequencer's 64 steps are in four 4-button rows of 16.
• Step indicates a trigger on that step (when it's lit red). See the Record
button below for instructions on how to program patterns, but you can
push the button to turn a programmed/recorded note off. To tie several
Arturia - MatrixBrute Manual - The Matrix
See
43