Cleaning Your Water Reservoir; Troubleshooting Guide - Ninja CF110 Series Owner's Manual

Care & Maintenance - cont.
Fig. 16
3 Once the water reservoir is filled with your cleaning
solution and water mixture (not exceeding the Clean
Cycle Max Fill line), simply press the CLEAN button
to activate the Clean Cycle. (Fig. 16)
NOTE: The Clean Cycle takes approximately 8 minutes
to fully descale and clean the machine.
4
Once the Clean Cycle is complete, empty and rinse the
water reservoir. Please take special care to thoroughly
clean the water reservoir to remove any cleaning
solution that could affect the flavor of your coffee.
5 Once the CLEAN light turns off, fill the water reservoir
with water up to but not exceeding the Clean Cycle Max
Fill line (30 oz.) and run 2 more Clean Cycles with fresh
water to rinse the internal parts of the brewer.
NOTE: If the CLEAN light illuminates on the next brew
after a Clean Cycle, this means there is still calcium
buildup on the brewer. Repeat steps above and the CLEAN
light will automatically shut off when it senses your Ninja
Coffee Bar ® is clean and free of calcium buildup.
Please call Customer Service at 1-877-646-5288 if the
brewer needs any servicing.
15 1-877-646-5288

CLEANING YOUR WATER RESERVOIR

1 Empty the water reservoir.
2 Hand wash with dish soap and rinse, or place on the
top rack of your dishwasher.
3 Clean the water reservoir shelf with cloth and warm
soapy water.

Troubleshooting Guide

PROBLEMS
If there is sediment at the bottom of the brewed coffee, this may be due to finely ground coffee in a
permanent filter.
Sediment in my coffee.
To reduce the amount of sediment in the brewed coffee use a slightly coarser grind or use a paper
filter.
If there are grounds in your coffee, check to make sure the brew basket did not overflow.
If there are too many grounds in the brew basket, or you are using a fine ground coffee, the
Grounds in my coffee.
grounds will flow into an overflow channel designed to make sure overflow is captured in the brew
vessel. For best results use medium ground coffee in the recommended measurements.
Brew basket dripping Run a Clean Cycle or wash the brew basket thoroughly with warm, soapy water.
after brew.
Check to see if the Drip Stop is set to the closed, no-drip position.
The Ninja Coffee Bar
for best results.
Paper filter falling
Be sure the paper filter is firmly pressed into the brew basket.
over.
Wet the corners of the filter for best results.
If problem persists, try using the permanent filter.
To keep your coffee hotter longer,
Coffee is not hot
If using a microwave safe mug with cream or milk, try pre-heating the cream or milk in the
enough.
microwave for 30 seconds.
Over Ice Brew is not
The Over Ice Brew is designed to brew hot coffee over ice to lock in the flavor for rich, smooth iced
cold. coffee. Make sure your cup or travel mug is filled all the way to the top with ice cubes.
If the coffee tastes weak, try adding more coffee grounds into the brew basket for the next brew
cycle.
Weak coffee.
If the coffee is still weak after adding more coffee grounds, try Rich Brew to make a stronger, more
concentrated cup.
Try using a coarser grind.
Coffee too strong.
If the coffee is still too strong, try using less coffee grounds.
Check to make sure the brewer is plugged in and water is in the water reservoir.
If the Drip Stop is in the open position, check that the brew basket is pushed all the way into the
Brew will not start.
brewer. If you hear 5 beeps, check that the Drip Stop is in the open position.
NOTE: The brew will begin, stop, and be quiet for a short period of time before it begins again. This
process is used to evenly saturate your coffee grounds.
A single-cup brew will take approximately 4 minutes.
Brew cycle is too slow.
If the brew cycle is taking longer than normal, run the Clean Cycle with the descaling solution.
POSSIBLE REASONS & SOLUTIONS
is designed to take a #2 cone filter. Be sure you are using this size and shape
®
pre-heat your mug by rinsing it with hot water from the tap.
ninjacoffeebar.com 16