Table of Contents
Advertisement
Camera interfaces
Pin Signal
1
2
3
4
5
6
7
8
9
10
11
12
13
14 Line-sync output Out
15 Frame-sync
Figure 13: Camera I/O connector pin assignment (Bigeye P-1100B/C Cool)
Bigeye P-132
Bigeye P-629
Bigeye P-1100
This jack is intended for the power supply as well as for controlling the camera
by the user.
Bigeye P-1100B Cool / P-1100C Cool
Direction Level
External Power
External GND
---
---
RXD
In
TXD
Out
Mode input
+
-
Trigger input
+
-
Exposure output
+
Out
output
Power supply (Pin 1-4)
The camera requires 12 V +5% at a current capacity of maximum 0.8 A.
After attaining the end cooling temperature (- 20 °C) the current capacity goes
down to approx. 1.9 ... 2.3 A. The exact value also depends on the ambient tem-
perature of the camera (not for Bigeye P-132B, because it is uncooled).
The camera requires 12 V +5% at a current capacity of maximum 2.8 A.
After attaining the end cooling temperature (- 20 °C) the current capacity goes
down to approx. 1.3 ... 1.7 A. The exact value also depends on the ambient tem-
perature of the camera.
The camera requires 12 V +5% at a current capacity of maximum 3.0 A.
+12 V DC
RS232
RS232
12V, 20 mA max.
12V, 20 mA max.
12V, 20 mA max.
5 V (at no load)
5 V (at no load)
Bigeye Technical Manual V2.0.0
Description
Power supply
max. 3.0 A
Reserved
Reserved
Serial control
Serial control
Internal pull-up resistor
Optocoupler input
Optocoupler output
Active low
Active low
31
Advertisement
Table of Contents
