Table of Contents
Advertisement
Camera interfaces
Camera
TriggerMode
Bigeye P-132B
On
Off
Bigeye P-132x Cool
On
Off
Note
Bigeye P-629: The timer has to be enabled via the
ExposureMode feature in order to control the exposure. Set the
TriggerMode feature to On if the electromechanical shutter
operation is needed, otherwise it will stay permanently open.
Beside the internal exposure control capabilities also direct exposure control
by an externally applied signal is possible. In this case the ExposureMode has
to be configured to Off to deactivate the internal timer.
Mode setting
The GigE Vision feature AcquisitionControl/TriggerMode setting provides a
method for switching the camera between different exposure control modes.
The individual function depends on the camera variant.
The Mode input (Pin 9) can be used to control this setting using an external sig-
nal.
Note
For more information see Chapter
32.
Note
The active state (externally low at pin 9 or TriggerMode = On) is
dominant, thus image-on-demand is active if one of either set-
tings is.
Description
Image-on-demand mode.
Exposure control via ExposureTime and DarkTime features
(ExposureMode = Timed) or externally (ExposureMode = Off).
Continuous mode with fixed exposure time and frame rate.
Image-on-demand mode.
Peltier cooling active.
Exposure control via ExposureTime and DarkTime features
(ExposureMode = Timed) or externally (ExposureMode = Off).
Continuous mode with fixed exposure time and frame rate.
Peltier cooling inactive (power saving).
Table 13: TriggerMode
Mode input (Pin 9)
on page
Bigeye Technical Manual V2.0.0
39
Advertisement
Table of Contents
