Acquisitioncontrol; Analogcontrols - AVT Bigeye Technical Manual

Appendix

AcquisitionControl

Feature
AcquisitionMode
AcquisitionStart
AcquisitionStop
TriggerMode
ExposureMode
ExposureTime
ExposureTimeAbs
ExposureTimeGranularity
ExposureTimeAbsMs
DarkTime
DarkTimeAbs
DarkTimeGranularity
DarkTimeAbsMs

AnalogControls

Feature
Gain
Description
This feature controls the acquisition mode of the software. This
feature works independently (!) of the chosen camera mode
(Continuous, IOD hardware trigger, IOD hardware timer). It
describes how many frames should be acquired.
Starts the image acquisition of the camera.
Stops the image acquisition of the camera.
Modifies the trigger mode of the camera. When the trigger mode
is "Off", the camera will generate frames independently. When
the trigger mode is "On" the camera is switched to the so called
IOD (image-on-demand) mode. In this mode the camera waits
for an external trigger signal or an timer pulse generated
internally. To control exposure and dark time, trigger mode must
be switched to "On".
Start or stop the internal exposure signal timer.
This feature is used to set the Exposure time (in microseconds).
This feature is used to set the Exposure time (in microseconds).
Exposure time granularity.
This feature is used to set the Exposure time (in milliseconds).
This feature is used to set the Dark time (in microseconds).
This feature is used to set the Dark time (in microseconds).
Dark time granularity.
This feature is used to set the Dark time (in milliseconds).
Table 18: Camera standard feature: AcquisitionControl
Description
This feature controls the selected gain as a raw integer value.
Table 19: Camera standard feature: AnalogControls
Bigeye Technical Manual V2.0.0
44