Aiwa xr-ms3 Service Manual page 10

NOTES
• PCMD is a MSB first, two's complement output.
• GTOP is used to monitor the frame sync protection status. (High: sync protection window released.)
• XUGF is the frame sync obtained from the EFM signal, and is negative pulse. It is the signal before sync
protection.
• XPCK is the inverse of the EFM PLL clock. The PLL is designed so that the falling edge and the EFM
signal transition point coincide.
• The GFS signal goes high when the frame sync and the insertion timing match.
• RFCK is derived from the crystal accuracy, and has a cycle of 136µs.
• C2PO reqresents the data error status.
• XROF is generated when the 16K RAM exceeds the ±4F jitter margin.
Monitor Pin Output Combinations
Command bit
MTSL1 MTSL0
0 0 XUGF
0 1 MNT1
1 0 RFCK
Output Data
XPCK GFS C2PO
MNT0 MNT3 C2PO
XPCK XROF GTOP
– 10 –