Jenn-Air su110 Use And Care Manual page 25

Oven Racks and Rack Supports
Oven Racks:
To remove, pull forward to the "stop" position; lift up on the front of the
rack and pull out.
Oven Rack Sul)por_s: To remove, lift support holders from slots at the front of the
oven then move supports away from oven wall. Pull forward to remove from oven. To
replace, reverse procedure. Be sure front supports are correctly in place so that racks
will be level.
Oven Thermostat Knob Adjustment
The oven thermostat knob can be adjusted if the oven temperature is too low or too
high and the length of time to cook ALL foods is too long or too short. Do NOT adjust
the thermostat knob if only one or two items are not baking properly.
To adjust the/hemosta| knob: _j Triangle
Turn the oven thermostat knob to OFF. (__Top Screw f_ .. ,_/
Remove the knob and turn it to the under-
neath side. Hold it so that the triangle is at the
top. (See Fig. 1) Loosen the two screws
slightly. Holding the skirt in place, move the
top screw by rotating the knob one notch, as
noted by one click, in direction necessary. If ___ _Skirl
notch indentation is not apparent, tighten
screws until clicking is heard. There are five
notches in each direction. One notch equals _ FIG. 1
approximately 10°F.
EXAMPLE: If the oven temperature is too
cool and ALL foods are requiring
a longer time period to cook, the
knob should be rotated to move
the top screw toward the word
"HOTTER". (See Fig. 2)
Tighten the screws while tightly holding
knob to skirt. To replace knob, match flat
part of knob opening with spring on the
shaft, returning to OFF position. .2
IMPORTANT: The oven thermostat knob should be adjusted one notch and then the
oven should be tested. (We recommend baking 2 -- 9" yellow layer cakes using a
purchased box mix.) If the oven temperature is still too low or too high, repeat the
procedure described above.
If the knob is rotated too far or in the wrong direction, rotate the knob in the opposite
direction until the center of the screw is directly under the triangle, which is the starting
point. Initiate the procedure again until the desired temperature is reached.
27