Table of Contents
Advertisement
Danfoss Link™ FT
3�1
Configuration
See Step-by-Step guide in Danfoss Link™ CC instruction
manual.
Green LED ON
Red LED ON
Green LED fast flash
Red LED short flash
RED LED slow flash
4
Factory reset
Turn off power on the safety switch on the front. Hold the
install button in while pushing ON the safety switch and
keep the install button pressed until the LED gives a red
flash (approx. 5 sec.)
5
Technical specifications
Operation voltage
Standby power
consumption
Installation Guide
Standby
Heating
Inclusion or link test
Inclusion not OK, goes to not
included.
Linktest not OK, goes to
missing link
Sensor failure
220-240 V~ 50/60 Hz~
Max. 1 W
7
Advertisement
Table of Contents
