E-Mail Messages - Sprint PPC 6600 User Manual

9.1 E-mail Messages: Using Messaging
You can set up a connection to an e-mail server so that you can
send and receive e-mail messages by using a modem or network
connection and Inbox on your device.
The ISP or network must use a POP3 or IMAP4 e-mail server and an
Note:
SMTP gateway.
You can use multiple e-mail services to receive your
messages. For each e-mail service you intend to use, first set
up and name the e-mail service. If you use the same service
to connect to different mailboxes, set up and name each
mailbox connection.
To set up an e-mail service:
1. Open Messaging on your device, tap Accounts, and then
New Account. Follow the directions in the New Account
Wizard.
2. Fill in your e-mail address then tap Next.
Tapping Next will initiate auto-configuration, which
attempts to connect your PPC6600 to your e-mail server
and automatically download the necessary e-mail
connection settings.
If auto-configuration is successful, you can skip steps

3-6 and immediately begin sending/receiving e-mail.
If auto-configuration is unsuccessful, you will need to

complete steps 3-6 to manually enter the settings.
3. Enter your name, User name and Password, then tap Next.
4. From the drop down menu select the Account type that
your e-mail provider supports (POP3 or IMAP4).
5. Enter a Name for your e-mail account then tap Next.
6. Enter your e-mail provider's server name information for
Incoming mail and Outgoing mail, then tap Finish.When
finished, to connect to your e-mail server, tap Accounts,
and then Connect.
Section 9: Exploring Messaging
109