Programming Your Remote; Auto Find Option - Hitachi 27CX22B 501 Service Manual

Table of Contents

Advertisement

REMOTE CONTROL
PROGRAMMING
YOUR REMOTE
If you're using Hitachi products, the remote is already
programmed for the most common codes:
TV = 121 and VCR = 215. For other brands, or if your
remote fails to control your Hitachi products, you'll have
4.
5.
4.
to
1.
2.
3.
4.
5.
6.
7.
program the remote.
7.
Make sure the batteries are installed.
Press and hold
PRG
key for about 5 seconds, then
release the
PRG
key.
8.
9.
Press the mode key to be programmed:
TV, CABLE,
VCR OR AUX.
Enter 3-digit product code from chart on next page.
Press and release
ENTER
to save the code.
Point remote at product and press
POWER
to test
product operation. If it does not turn on, reprogram
remote using a different code.
Repeat above steps to program remote for another
*
Point the remote at the product.
Press and release
POWER
repeatedly, about once a
second, until your product turns Off.
Press
ENTER
immediately to save the code.
Press
POWER
to turn On your product.
Test your product. If the remote fails to operate the
functions you use most often, use Auto Find again to
search for a better code. (Auto Find resumes its
search after the last code that was entered and saved
in step 7).If the product you want to control has not
turned off, your remote will not work with that
product.
proauct.
T/,
sv cancel Auto Find, press PRG at any time.
Enter "O-O-O," then press
ENTER
within two
seconds.
AUTO FIND OPTION
(ALTERNATE
PROGRAMMING
METHOD)
If you've tried all codes for your product and none
operates it, you can use Auto Find to search for the code
you need. Follow the steps below for each product you
want to program. Please be patient while using this
method; the remote may have to search all of the codes
shown in the chart on the next page.
To Auto Find a Code
Refer to product operating guide for detailed
programming
information.
1. Turn On the product you want to operate.
2. Press and hold
PRG
key for about 5 seconds, then
release the
PRG
key.
3. Press the mode key to be programmed:
TV, CABLE,
VCR OR AUX.

Advertisement

Table of Contents
loading

Table of Contents