Cleaning The Door Seal; Cleaning The Water Inlet Filters - LG WM9500H*A Owner's Manual

Cleaning the Door Seal

Clean the door seal once a month to prevent build-up
of dirt.
1
Wear rubber gloves and protective goggles.
2
Dilute 3/4 cup (177 ml) of liquid chlorine
bleach in 1 gallon (3.8 L) of water.
3
Wipe around the door seal.
Soak a sponge or a soft cloth in this diluted
solution and wipe all around the door seal.
4
Wipe dry.
After cleaning, wipe up any moisture with a dry
towel or cloth.
5
Leave the door open to allow the door seal to
dry completely.
CAUTION
• Cleaning the door seal with undiluted bleach
may cause malfunction of the door seal and
washer parts. You must add water to the bleach
before using it.
Cleaning the Water Inlet
Filters
If the washer does not fill properly, an error message
will show on the display. The inlet valve filter screens
could be plugged by hard water scale, sediment in
the water supply, or other debris.
CAUTION
• The inlet screens protect the delicate parts of
the inlet valve from being damaged by particles
that could enter the valves with the water
supply. Operating the washer with these filters
removed could cause a valve to stick open
resulting in flooding and/or property damage
• Do not use the washer without the inlet filters. If
you use the washer without the inlet filters it will
cause leaks and malfunction.
• If you use the washer in an area with hard
water, the inlet filter may clog due to lime
buildup.
1
Turn off both water faucets completely.
2
Unscrew the hot and cold water hoses from
the back of the washer.
3
Carefully remove the filters from the water
valves.
4
Remove foreign objects and soak the filters
in white vinegar or a lime scale remover.
If using a lime scale remover, follow the
manufacturer's instructions. Be careful not to
damage the filters while cleaning them.
5
Rinse filters thoroughly and press them back
into place.
6
Flush then reattach the water hoses.
Before reattaching the hoses, flush the hoses
and water lines by running several gallons of
water into a bucket or drain, preferably with the
faucets wide open for maximum flow.
NOTE
• An message may blink on the display when
the water pressure is weak or an inlet filter is
clogged with dirt. Clean the inlet filter.
MAINTENANCE 41