Cleaning The Door Seal; Cleaning The Water Inlet Filters - LG WM3600HVA/00 Owner's Manual

Table of Contents

Advertisement

24 MAINTENANCE
5
Wipe off any moisture with a dry towel or cloth
after cleaning.
6
Replace the detergent dispenser drawer.
WARNING
Do not spray water inside the cabinet. Doing so

Cleaning the Door Seal

Clean the door seal once a month to prevent build-up
of dirt.
1
Wear rubber gloves and protective goggles.
2
Dilute 3/4 cup (177 ml) of liquid chlorine
bleach in 1 gallon (3.8 L) of water.
3
Wipe around the door seal.
Soak a sponge or a soft cloth in this diluted
solution and wipe all around the door seal.
4
Wipe dry.
After cleaning, wipe up any moisture with a dry
towel or cloth.
5
Leave the door open to allow the door seal to
dry completely.
CAUTION
Cleaning the door seal with undiluted bleach
may cause malfunction of the door seal and
washer parts. You must add water to the bleach
before using it.
Cleaning the Water Inlet
Filters
could be plugged by hard water scale, sediment in
the water supply, or other debris.
CAUTION
The inlet screens protect the delicate parts of
the inlet valve from being damaged by particles
that could enter the valves with the water supply.
could cause a valve to stick open resulting in
If you use the washer in an area with hard water,
1
Turn off both water faucets completely.
2
Unscrew the hot and cold water hoses from
the back of the washer.
3
valves.
4
white vinegar or a lime scale remover.
If using a lime scale remover, follow the
manufacturer's instructions. Be careful not to
5
into place.
6
Flush then reattach the water hoses.
water lines by running several gallons of water
into a bucket or drain, preferably with the faucets
NOTE
An
message may blink on the display when the

Advertisement

Table of Contents
loading

Table of Contents