MC Crypt DJ-80 Instruction Manual page 28

Connection and control elements
(9) CROSS-FADER
With the aid of this slide control, cross-fading takes place between the channels CH1 and CH2.
One channel is faded out on operating the slide control (becomes quieter). At the same time, the other
channel is faded in (becomes louder). With the cross-fader slide control in the centre position, both channels
are reproduced equally.
(10) Fader CH1/CH2
The channel faders are for adjusting the level of each channel.
Slide control to the bottom position = minimum channel level
Slide control to the top position = maximum channel level
The channel fader of channels that are not in use should be slid right down. This reduces the possibility
of interference.
(11) Switch DJ MIC
The DJ microphone is switched on or off using this switch.
(12) Display DJ MIC ON
When the DJ microphone is switched on, the operating indicator lights up.
(13) Gain control (MIC)
This rotary control is used to set the microphone volume of the DJ microphone.
(14) TALK control (MIC)
With this control you set the volume for the two other channels when talking into the DJ microphone.
The higher the setting the more intensive the attenuation. In position „0", the other channels are not
influenced.
(15) LOW/MID/HIGH control (CH1/CH2)
You can change the tone of the channels CH1 and CH2 using the equaliser controls.
HIGH = treble control
MID = mids control
LOW = bass control
Turn the control knob as far as it will go to the left for maximum reduction.
Turn the control knob as far as it will go to the right for maximum increase.
Central position = no influence of the signal through the control
28