Lexus GS 450h2011 Manual page 425

■ Programming a Rolling Code system
If your device is Rolling Code equipped, follow the steps under the
heading "Programming the HomeLink
steps listed below.
Locate the learn button on the ceiling mounted garage door
STEP 1
opener motor. The exact location and color of the button may
vary by brand of garage door opener motor.
Refer to the operation manual supplied with the garage door opener
motor for the location of the learn button.
Press the learn button.
STEP 2
Following this step, you have 30 seconds in which to initiate step 3
below.
Press and hold the vehicle' s programmed HomeLink
STEP 3
2 seconds and release it. Repeat this step once again. The garage
door may open.
If the garage door opens, the programming process is complete. If the
door does not open, press and release the button a third time. This third
press and release will complete the programming process by opening
the garage door.
The ceiling mounted garage door opener motor should now recognize
the HomeLink
Repeat the steps above to program another rolling code system
STEP 4
for any of the remaining HomeLink
GS_HV_U (OM30C14U)
May 21, 2010 2:41 pm
®
®
transceiver and operate the garage door.
3-7. Other interior features
" before proceeding with the
®
button for
®
buttons.
3
425