Lexus GS 450h2011 Manual page 424

3-7. Other interior features
STEP 2
STEP 3
Repeat the steps above to program another device for each of
STEP 4
the remaining HomeLink
424
GS_HV_U (OM30C14U)
May 21, 2010 2:41 pm
Press and hold one of the
®
HomeLink buttons and the trans-
mitter button.
®
HomeLink
changes from a slow to a rapid
flash after 20 seconds, release
both buttons.
Test the HomeLink
pressing the newly programmed
button.
If a HomeLink
programmed for a garage door,
check to see if the garage door
opens and closes. If the garage
door does not operate, see if your
remote control transmitter is of the
rolling code type. Press and hold
the programmed HomeLink
ton. The remote control transmitter
is of the rolling code type if the
®
HomeLink indicator light flashes
rapidly for 2 seconds and then
remains lit. If your transmitter is of
the rolling code type, proceed to
the heading "Programming a roll-
ing code system".
®
buttons.
When the
indicator light
®
operation by
®
button has been
®
but-