Configuring The Terminal - ATB HiSpeed 8200 Installation Manual

Configuring the Terminal

Step 1
Picture #3
Register the Terminal to the Base
A maximum of seven terminals can be registered to one communications base for IP setups. Only 1
terminal should be setup on Dial. A maximum of seven terminals can be registered to one communications
base. Every terminal must be registered individually. A terminal can only be registered to one
communications base. To use a different base, register the terminal to that base.
Press the blue admin button twice (see picture #3)
The terminal will ask for admin code, enter 17 & push OK.
To Select REGISTER BASE (which is Highlighted) Press Ok.
ENTER BASE ID prompt appears, Key in the 8-digit Base ID which begins with 12 (found on the
bottom of the communications base) and press OK.
The device will say please wait for a few seconds then REGISTER BASE is highlighted again.
Press Can/Ann until the READY screen reappears. The handheld can now talk to the
communications base.
If you require TIPS, CASH BACK or INVOICE NUMBERS continue with Step 1. If not proceed to Step 2.
Press blue admin key twice, enter admin code 08 & push OK.
Use F1 to scroll down to the option you want to enable, make sure it is highlighted, press OK, and
then enable it by pressing F1 for yes
The screen will now say COMMS TYPE.
Press red cancel button (see picture #3) twice.
The screen will say – TERMINAL SETUP REQUIRED
.
4