Electrical Connections - Pentair Pool Products MiniMax 200 Operation & Installation Manual

Section III. Installation

ELECTRICAL CONNECTIONS

Electrical Rating
This heater is designed to operate at 120 or 240 VAC. It is not recommended to be connected to OR operate on a 208 VAC.
The installation must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code,
ANSI Z223.1/NFPA 54 and/or CSA B149.1, Natural Gas and Propane Installation Codes. If an external electrical
source is utilized, the heater, when installed, must be electrically grounded and bonded in accordance with local
codes or, in the absence of local codes, in the USA, with the National Electrical Code, ANSI/NFPA 7; in Canada, with
Canadian Electric Code, CSA C22.1.
Always use crimp type connectors when connecting two wires.
60 Hz 120 / 240 Volts AC, single phase
WHITE
COMMON MALE
CONNECTOR
BLUE
FM CONNECTOR
FOR USE WITH
120 VAC
LINE TERMINAL BLOCK
GREEN WIRE
INTERNAL
WHITE WIRE
FACTORY WIRES
BLACK WIRE
CAUTION
NOTE
CAUTION
GROUND
CONNECTION
NEUTRAL / WHITE 120 VAC
LINE #1 FOR 240 VAC
HOT / BLACK 120 VAC
LINE #2 FOR 240 VAC
RED/BROWN
FM CONNECTOR
FOR USE WITH
240 VAC
TERMINAL BLOCK
FOR AC INPUT
120 / 240 VOLT SINGLE
PHASE "See Below"
Figure 16.
Figure 17.
18