Toshiba e-STUDIO5506AC Quick Start Manual page 17

Saving energy when not in use – energy saving modes –
The following modes are available; Automatic Energy Save mode, Sleep mode, and Super Sleep mode.
The table below shows the procedures to switch modes manually and conditions under which it enters
into or recovers from each mode.
Energy saving Procedure to switch
modes modes
When a specified
Automatic period of time
Energy Save passed since the last
mode use of the equipment.
When you press the
[ENERGY SAVER]
*2
Sleep mode button or when a
specified period of
time *3 has passed.
When you press the
[ENERGY SAVER]
button *2 or when a
Super Sleep specified period of
*3 *6
mode time has passed.
*1 The default value is 1 minute.
*2 The [ENERGY SAVER] button on the control panel.
*3 The default value is 1 minute .
*4 The Wireless LAN/Bluetooth Module and/or e-BRIDGE ID Gate.
*5 Any of IPX, AppleTalk and other protocols. When the IPsec function is enabled or the Ethernet speed is set to [AUTO
(-1000MB)] or [1000BASE FULL], the equipment enters Sleep mode. For details, see the following guide:
& TopAccess Guide (PDF) : "Chapter 8: [Administration] Tab Page" - "[Setup] Item List"
*6 Depending on the network environment, the time for switching to Super Sleep mode may take more than 10 minutes even if
it is set to 10 minutes or less.
To change the time for entering each mode, see the following guide:
& MFP Management Guide (PDF) : "Chapter 2: SETTING ITEMS (ADMIN)" - "GENERAL"
For the European version
Contact your service representative to change the default settings.
When the set time for switching to Automatic Energy Save mode is the same as Sleep mode or Super
Sleep mode, the equipment enters into Sleep mode or Super Sleep mode.
If an original is placed on the original glass during energy saving mode, the size is not detected even when the
equipment recovers from this mode. After pressing the [START] button or the [POWER] button to recover from
the mode, place it on the glass again.
Conditions to enter
the mode
*1
has
—
When a particular
option *4 is installed or
when a particular
*5
protocol is enabled.
When a particular
*4
option is not
installed and also a
particular protocol
disabled.
Status of equipment
A message is displayed
to indicate the energy
saving status.
The touch panel
display turns off and
the [ENERGY SAVER]
button turns green.
The touch panel
display turns off and
the [ENERGY SAVER]
*5
is button turns green.
Turning ON/OFF
Conditions to recover
from the mode
When you press the
[ENERGY SAVER]
button, or when print
data or fax data are
received.
Same as the Automatic
Energy Save mode.
When you press the
[ENERGY SAVER]
button, when print or
fax data are received
through a wired LAN,
or when the time set
for Scheduled Print
has come.
17
1