Filling The System - Baxi luna platinum+ Instruction Manual

CALLING IN THE AUTHORISED TECHNICAL SERVICE CENTRE
If the symbol
TECHNICAL SERVICE CENTRE.
FAULTS TABLE
Description of fault
10
External probe sensor
20
28
NTC fumes sensor
40
NTC return sensor
NTC DHW sensor
50
52 Solar DHW sensor (if connected to a solar plant)
73 Solar manifold sensor (if connected to a solar plant)
83
84
(internal fault)
98 Accessory not detected or recognized (*)
109
Air in boiler circuit (temporary fault)
Safety thermostat tripped due to overtemperature.
110
(pump blocked or air in heating circuit)
111 Safety thermostat tripped due to overtemperature.
117 Pressure in hydraulic circuit too high
118
(*)
is displayed permanently if the accessory is not recognized.

8. FILLING THE SYSTEM

Regularly check that the pressure displayed on the pressure gauge B
A
B Pressure gauge
valves in the system, ensure the water enters slowly in order to prevent the formation
of air inside the primary circuit until operating pressure is reached. Lastly, vent any
radiators in the system. BAXI declines all liability for damage deriving from the presence of
air bubbles in the primary exchanger due to the incorrect or imprecise observance of the
above.
7219836.01 (1-04/15)
, contact the AUTHORISED TECHNICAL SERVICE CENTRE.
Description of fault
No circulation safety trip
125
(control performed via a temperature sensor)
128
130
Fumes NTC tripped due to overtemperature
133
Ignition failure (4 attempts)
151
Boiler board internal fault
152 Generic parameter setting error
153
160
Fan fault
321
Generic parameter setting error of solar plant
343
(if connected to a solar plant)
384
385
386 Fan speed threshold not reached
No circulation safety trip
430
(control performed via a pressure sensor)
No functional earth or safety thermostat tripped due to over
432
temperature (E110)
A
40
bis