i3 International SAN iS316 User Manual page 76

Level Type
INFO PD inserted
WARNING PD removed
ERROR HDD read error
ERROR HDD write error
ERROR HDD error
ERROR HDD IO timeout
INFO PD upgrade started
INFO PD upgrade finished
WARNING PD upgrade failed
INFO PD RPS started L2L
INFO PD RPS finished L2L
ERROR PD RPS failed L2L
Hardware Events
Level Type
WARNING ECC single
ERROR ECC multiple
INFO ECC dimm
INFO ECC none
INFO SCSI bus reset
ERROR SCSI host error
ERROR SATA enable device
fail
ERROR SATA EDMA mem
fail
ERROR SATA remap mem
fail
ERROR SATA PRD mem fail
ERROR SATA revision id fail
ERROR SATA set reg fail
ERROR SATA init fail
ERROR SATA diag fail
ERROR Mode ID fail
ERROR SATA chip count
error
INFO SAS port reply error
INFO SAS unknown port
reply error
INFO FC port reply error
INFO FC unknown port
reply error
INFO Port linkup
INFO Port linkdown
EMS Events
Level Type
INFO Power install
ERROR Power absent
INFO Power restore
ERROR Power fail
WARNING Power detect
INFO Fan restore
ERROR Fan fail
Description
Disk <slot> is inserted into system
Disk <slot> is removed from system
Disk <slot> read block error
Disk <slot> write block error
Disk <slot> is disabled
Disk <slot> gets no response
PD [<string>] starts upgrading firmware process.
PD [<string>] finished upgrading firmware process.
PD [<string>] upgrade firmware failed.
Assign PD <slot> to replace PD <slot>.
PD <slot> is replaced by PD <slot>.
Failed to replace PD <slot> with PD <slot>.
Description
Single-bit ECC error is detected at <address>
Multi-bit ECC error is detected at <address>
ECC memory is installed
Non-ECC memory is installed
Received SCSI Bus Reset event at the SCSI Bus <number>
SCSI Host allocation failed
Failed to enable the SATA pci device
Failed to allocate memory for SATA EDMA
Failed to remap SATA memory io space
Failed to init SATA PRD memory manager
Failed to get SATA revision id
Failed to set SATA register
Core failed to initialize the SATA adapter
SATA Adapter diagnostics failed
SATA Mode ID failed
SATA Chip count error
SAS HBA port <number> reply terminated abnormally
SAS frontend reply terminated abnormally
FC HBA port <number> reply terminated abnormally
FC frontend reply terminated abnormally
The Port <number> link status is changed to Up.
The Port<number> link status is changed to Down.
Description
Power (<string>) is installed
Power (<string>) is absent
Power (<string>) is restored to work.
Power(<string>) is not functioning
PSU signal detection(<string>)
Fan (<string>) is restored to work.
Fan (<string>) is not functioning
76