Table of Contents
Advertisement
Currently, the system only supports and communicates with Smart-UPS series by APC (American Power
Conversion Corp, http://www.apc.com/) and Magatec UPS.
TIP:
Connection with other vendors of UPS can work well, but they have no such
communication features with the system.
Now we support the traditional UPS via serial port and network UPS via SNMP. If using the UPS with serial
port, connect the system to UPS via the included cable for communication. (The cable plugs into the serial
cable that comes with the UPS.) Then set up the shutdown values for when the power goes out.
This table shows the available options and their descriptions.
Options
Description
UPS Type
Select UPS Type:
Shutdown Battery
When the battery level goes down and lower than the configured threshold, the
Level (%)
system will auto shutdown. This function will be disabled if the configured
threshold is set to 0.
Shutdown Delay
When there is the power outage happening, if the power cannot be recovered
(Seconds)
within the configured time, such as 30 seconds, the system will auto shutdown at
the moment. This function will be disabled if the configured seconds is set to 0.
Shutdown UPS
The status of shutdown UPS:
IP Address
The IP address of the network UPS.
(This option is only
visible when the
UPS type is Smart-
UPS (SNMP).)
Community
The SNMP community of the network UPS.
(This option is only
visible when the
UPS type is Smart-
UPS (SNMP).)
Status
The status of UPS:
None: No UPS or other vendors.
Smart-UPS (Serial port): APC Smart-UPS with serial port.
Smart-UPS (SNMP): APC Smart-UPS with network function.
Megatec-UPS: Megatec UPS.
ON: The system will send the command to shutdown the connected UPS if
one of the above functions is triggered when the power outage is
happening.
OFF: Disable this function.
Detecting...
54
Advertisement
Table of Contents
