Install Properly; Level Refrigerator-Freezer; Remove Sales Labels; Clean It - Whirlpool ET14AK Use And Care Manual

Install properly.. .
1 Allow 3 inches r 7 5 cm] between overhead cabi-
nets and refrigerator top
2 Allow at least an inch (2 5 cm] between the
refrigerator condenser on the back and the wall
3 Allow '1, Inch 11 25 cm] on each srde of the
refrigerator for ease of installatron
4 If the refrigerator IS tc be against a wall, you might
want to leave extra space on the hinge side so the
door can be opened wider
Level refrigerator-freezer.. .
Thts refrigerator has 2 threaded levellrng legs that are
shipped in a separate package
1 Screw these legs all the way Into bolt holes in the
bottom front corners of the refrigerator
2 Slide the refrigerator into place.
3 Adjust front legs to level the refrigerator
To raise corners turn legs rn directton shown.
To lower corners, turn legs in direction shown.
4. Check with level
Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and
any inside labels before using the refrigerator
To remove any remaining glue:
1 Rub briskly with thumb to make a ball then remove
OR
2 Soak area with liquid hand dishwashing detergent
before removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
Clean it.. .
0 r
697
7. --\
Clean your refrigerator o -.L
before using it
,"
1 11
See cleantng instructrons
I, 4;'
on page 8
Plug it in...
3-prong
grounding type
wall receptacle
rong
ing plug
t
Refrigerator
Power Cord
RECOMMENDEDGROUNDING METHOD
A 115 volt. 60 Hz AC only 15 or 20 ampere fused
and properly grounded electrical supply IS re
quired It IS recommended that a separate circuit
serving only this appliance be provIdea
Do not use an extension cord. Use a recep-
tacle which cannot be turned off with a switch
or pull chain. See indrvidual electrIcal require-
ments and grounding Instructron sheet In your later-
atJre package
4