Sony MXD-D5C Service Manual page 32

7. TEST MODE DISPLAYS
[DISPLAY]
Each time the button is pressed, the display changes in the following order.
When CPLAY and CREC are started, the display will forcibly be switched to the error rate display as the initial mode.
1. Mode display
Displays "TEMP ADJUST" (C03), "CPLAY2MODE" (C36), etc.
2. Error rate display
Displays the error rate in the following way.
C = AD =
C = : Indicates the C1 error.
AD = : Indicates ADER.
3. Address display
The address is displayed as follows. (MO: recordable disc, CD: playback only disc)
h = s = (MO pit and CD)
h = a = (MO groove)
h = Indicates the header address.
s = Indicates the SUBQ address.
a = Indicates the ADIP address.
Note: "–" is displayed when servo is not imposed.
MEANINGS OF OTHER DISPLAYS
Display
N
X
REC
TOC EDIT
L.SYNC
OVER
B/1
A-REP
TRACK/(LP4)/calendar frame
DISC/LP2
SHUF
MONO
32
When Lit
Servo ON
Tracking servo OFF
Recording mode ON
CLV low speed mode
ABCD adjustment completed
Tracking offset cancel ON
Tracking auto gain OK
Focus auto gain OK
Pit
High reflection
CLVS
CLV LOCK
C1 error and jitter display
AD error and jitter display
Contents
When Off
Servo OFF
Tracking servo ON
Recording mode OFF
CLV normal mode
Tracking offset cancel OFF
Groove
Low reflection
CLVA
CLV UNLOCK
Mode display
Error rate display
Address display
Auto gain display
(Not used in servicing)
Detrack check display
(Not used in servicing)
IVR display
(Not used in servicing)
(Not used in servicing)
(Not used in servicing)