Adjustment Of The Slot Size And Its Correct Setting - PRO Nekson 2F User Manual

12

Adjustment of the slot size and its correct setting

Necessary to remember! According to the thickness of counted banknotes, you
need to maintain the sensitivity level of density detection between upper and lower
insert rollers. Regulations are adjusted by a screw, placed on the upper panel of a
counter (picture 1-5) It is convenient to adjust the clearance using a coin. If you turn
it right, the clearance will decrease, if you turn left-increase.
It is important to remember, for different currencies, depending on the thickness of
the banknotes, you must correctly adjust the slot (Figure C position 4) between the
upper and lower feed rollers. Adjusting the feeder slot size is possible by using the
paper thickness adjustment screw (Fig. 1-5). Turn the screw counterclockwise to
decrease the feeder slot size and clockwise to increase the size. Adjusting the feed-
er slot size should be done smoothly, with adjustments of no more than 1-2 degrees
(1/5 division).The feeder slot should be larger for excessively worn banknotes, dirty
banknotes and USD. The feeder slot should be smaller for "new" banknotes and
EURO banknotes. If in the process of regulation the counter does often mistakes
such as CHAIN-IR or and DOUBLE, you should decrease the clearance.
- If adjusting the feeder slot size results in the sensor responding slowly, slow sep-
aration of joined banknotes, irregular stacking of banknotes, error MISS-IMAGE,
then the slot size should be smoothly increased.
To check whether the setting of the feeder slot is correct, it is necessary to run the
following steps:
Fig. B
20