Philips 220S W9FS /00 Service Manual page 61

5. B rightness level sets to maximum.
6. S martR esponse set to "High".(N/A for this model)
7. G amma T able turn off to achieve
8. F astest response time. (N/A for this model)
9. S mart C ontrast set to "On"
C . Image V iewing
i. P urpose: Design for image viewing application, especially in slide show. T he screen is
dominated by picture. P ower point presentation could use this profile also.
ii. E nhancement P oint:
1. Dynamic contrast enhancement by histogram analysis (DLC ) should be off.
2. S harpness and color to be enhanced 75%.
3. C olor temperature 6500°K
4. B rightness level sets to maximum.
5. S mart R esponse set to "Off". (N/A for this model)
6. S mart C ontrast set to "Off".
D. E conomy
i. P urpose: Adjust brightness level for reducing power consumptions
ii. No optimization by S mart Image.
iii. Design:
1. B rightness level set to 70%, a little higher brightness level than laptop P C ,
fine tune brightness level before DV T exit.
2. C olor temperature set to 6500K .
3. G amma T able is turn on.
E . Off
i. P urpose: No optimization by S martImage.
ii. Design:
1. T his will follow user OS D setting. If any change by user, it will be saved.
W hen switch back from other S martImage profiles, it will go back to last
saved setting.
2. G amma T able is turn on to reduce bad color tracking.
3.14.1.7 Demo mode
A. P urpose: B uilt-in demo mode for sales in-store demo.
B . Design:
G eneral P roduc t S pec ific ation
220SW 9 L CD 61