Governor Oil Filter - Replace; Oil Pipe - Inspect; Fig. 8-17Oil Pipe And Clip - Inspect And Replace - Mitsubishi S6B Operation & Maintenance Manual

Chapter 8 PERIODIC INSPECTION AND MAINTENANCE PROCEDURES

Governor oil filter - Replace

When draining oil or changing the oil filter, wear
gloves. Hot engine oil and parts may cause burns.
1. Prepare a drip pan and place it under the governor
filter.
2. Using a filter wrench, remove the governor oil filter.
3. Prepare a new governor oil filter, and clean the
gasket.
4. Apply clean engine oil to gasket.
5. Screw the governor oil filter onto the filter bracket
by hand.
6. Remove the plug from filter bracket, and pour en-
gine oil until the filter is filled with out.
7. Then, reinstall the plug.
8. Operate the priming pump or wing pump to circu-
late engine oil. Check to make sure oil does not
leak from filter mounting surface. If oil leaks, tighten
the filter again.

Oil pipe - Inspect

Oil pipe and Clip - Inspect and Replace
Visual inspection in every 2000 service
hours
Loosen clamp fixing bolt and check clip wear and pipe
metal contact with clamp. If defective, replace the pipe
assembly with a new one.
In every other major overhaul
Replace the pipe assembly with a new one.
8-12
Air vent plug
Fig. 8-16 Governor oil filter - Replace
Clip
Fig. 8-17 Oil pipe and Clip - Inspect and Replace
Clamp