Blackstar ID:60TVP-H Owner's Manual page 7

Effects
Up to three studio quality effects can be switched on at any time.
11. MOD (Modulation)
Press this switch to turn the modulation effect on, off, or focus the effect for editing.
This setting is saved when you store a patch.
12. DLY (Delay)
Press this switch to turn the delay effect on, off, or focus the effect for editing. This
setting is saved when you store a patch.
13. REV (Reverb)
Press this switch to turn the reverb effect on, off, or focus the effect for editing. This
setting is saved when you store a patch.
With all three of the effect switches the ED will show what state it is in
LED Effect State
ED not on Effect off
ED red Effect on but not 'focused' for editing
ED green Effect on and 'focused' for editing
Repeatedly pressing each effect switch on the front panel has the following effect
Effect off Turns the effect on and 'focuses' the effect. Any previously focused effect
reverts to an 'on' state
Effect on but not 'focused' Focuses the effect. Any previously focused effect reverts to an 'on' state
Effect on and 'focused' Turns the effect off. If any other effect(s are on, the previously 'focused'
effect resumes being 'focused'
NOTE: Only one effect may be 'focused' at any time
14. Effect Type
This changes the effect type and edits a parameter of the currently 'focused' effect
(modulation, delay, or reverb .
Each segment represents a different effect (four for each type of effect . An
ED shows which effect type is currently active. The distance travelled through
the 'segment' modifies an effect parameter. The Effects Table below shows the
modifiable parameters
This setting is saved when you store a patch.
15. Effect Level
This modifies an effect parameter. For modulation and delay effects, turning the evel
control while holding down the Tap button (16 modifies the rate/time of the effect.
12
Description
Effect not active
Effect is active, but not affected by the front
panel effect controls
Effect active and affected by the front panel
effect controls
The Effects Table below shows the modifiable parameters
This setting is saved when you store a patch.
16. Tap
The Tap button is used to set the rate/time of the current 'focused' effect. The time
between each press of the tap button defines the rate set.
Once set, the Tap ED will flash in time with the set rate of the currently 'focused'
effect.
The Effects Table below shows the modifiable parameters
Effects Table
Effect Segment Parameter
MODULATION
Phaser Mix
Flanger Feedback
Chorus Mix
Tremolo Frequency modulation depth
DELAY
inear Feedback
Analogue Feedback
Tape Feedback
Multi Feedback
REVERB
Room ize
Hall ize
pring ize
Plate ize
This setting is saved when you store a patch.
Master
17. Resonance
The Resonance control sets the overall bass response. At lower settings the cleans
will be tight and funky and overdrives will be focused in their bass response. At
increased settings the clean sounds will be become full and warm, whilst the crunch
and overdrive tones will be more bass heavy and resonant.
This is a global setting and not saved when storing a patch.
Level Parameter Tap Parameter
Depth peed
Depth peed
Depth peed
Amplitude modulation depth peed
Delay level Time
Delay level Time
Delay level Time
Delay level Time
Reverb level -
Reverb level -
Reverb level -
Reverb level -
13