Demo Mode; Factory Reset - Blackstar ID:60TVP-H Owner's Manual

Demo Mode

When the ampli er is rst switched on after purchase, or after a factory reset, it will
be in Demo Mode'. The sound you hear will re ect the physical position of the front
panel knobs as it will be in Manual Mode. All effects, plus T P will be turned off.
All ampli er patch locations will contain
created and stored in Demo Mode but the original factory default patches and
settings will be restored each time the ampli er is turned off and turned on again.
To exit Demo Mode, hold down the Manual button 22 while switching the ampli er
on. The ank ED 23 will change from red, to orange, to green and then turn off
to indicate that Demo Mode has been deactivated. If the Manual button is released
before the ank ED has cycled through all colours and switched off, then the
operation is cancelled and the ampli er will remain in Demo Mode.
lackstar's Insider software can also be used to exit Demo Mode. From within the
program, right click on the Demo Mode label and select 'Disable'.
8
lackstar factory defaults. Patches can be

Factory Reset

The default factory patches and settings can be restored to your ampli er at any
time. imply hold down the MOD, D Y and RE
switching on the ampli er. The bank ED will illuminate, and change from green, to
orange, to red, to indicate that a factory reset is imminent. This process will take a
total of two seconds. If any of the MOD, D Y and RE buttons are released before
the bank ED has cycled through all colours and switched off, then the operation is
cancelled and the ampli er will remain unaffected.
Once this is complete the ampli er will be in Demo Mode again.
IMPORTANT NOTE: This process will overwrite any user content.
buttons simultaneously, whilst
9