Cleaning And Storing - maniquick clean & easy Operating Instructions Manual

Roto-clean system water-resistant exfoliating set
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 10

ClEANING AND STORING

Clean the unit and all applicators each time after each use.
Do not use any alcohol, acetone, petrol, abrasive cleaning agents etc, to clean
the plastic parts.
1.
Rinse applicators with tap water no hotter than 50° C or 122° F.
2.
Rinse the brushes thoroughly, including the inside parts to remove any
residue.
3.
Tip: If the filaments have become deformed, you can restore them to their
original shape by soaking them in warm water.
4.
Use a damp cloth to remove any residue remaining on the unit
5.
Allow all the parts to air dry
6.
Store the unit and parts in the box for next usage.
IMPORTANT: If the unit is not to be used for a long time, make sure to remove
the batteries.
MAINTENANCE AND REplACEMENTS
Replace the brushes every 2 to 3 months for good cleansing and exfoliation results.
Replace the brush if the deformed filaments can no longer be restored to their
original shape. Worn filaments will move impurities around rather than remove
them. They could also irritate your skin.
CONDITIONS fOR SERvICE UNDER GUARANTEE
1.
SANICO Srl guarantees the absence of faults and mechanical defects and
the completeness of the product when it is sold.
2.
Repairs can be done only at Service Centres authorized by SANICO Srl or
by the Authorized Distributor in the country where you have purchased
the appliance.
3.
The duration of the period of guarantee on the materials and on
manufacturing and operating defects is 2 years with effect from the
date of sale, subject to all the conditions for the Purchaser shown in the
Instructions for use. The obligations of guarantee do not cover expendable
materials: electrode cups, elastic bands, power supply cables etc..
4.
Complaints relative to the product must be presented directly to the
authorized service centre. The service centre, on the basis of an agreement
with the Vendor, is competent to establish the cause and nature of the
fault. The product will be replaced only if it cannot be repaired.
5.
The owner will provide to deliver the product to the after-sales service
center, as per the delivery instructions that can be requested by e-mail:
info@maniquick.com.
6.
The time necessary for the repair under guarantee will be subject to the
degree of seriousness of the fault.
7.
The responsibility of SANICO Srl under these conditions of guarantee will
be limited to the amount paid by the Purchaser for the product in question.
The guarantee on the product will not be applied in the following cases
certificate of guarantee filled in incorrectly or falsified; serial number (if
applicable for the specific product) damaged or removed;
absence of commercial and financial documents (cash receipt, delivery
note) proving the purchase;
opening or repair of the product by the Purchaser or by an unauthorized
Service Centre;
defects following failure by the Purchaser to observe the rules for use,
storage and transport of the product shown in the relative technical
and regulations documentation, in which case the regulations of the
aforementioned documentation which have been infringed must be
specified;

Advertisement

Table of Contents
loading

Table of Contents