Replacing The Media Wiper; Clearing Jams; Replacing/Adjust Media End Caps - Brady BBP 30 User Manual

Replacing the Media Wiper

Materials Required
• Media Wiper (5 pack) Kit, Cat #B31-WIPER (sold separately)
To replace the media wiper:
Remove power and media from the printer (see
1.
LIft and hold the wiper arm while grasping the tab of the wiper insert [2].
2.
Pull the tab slightly forward and then slide the wiper insert out of the wiper arm.
3.
To replace the wiper, insert the lip of the wiper insert into the slot [4] of the wiper arm and
4.
slide in until the tab snaps into place.
Replace the ribbon and tape.
5.
Close all covers and plug in the power cord.
6.

Clearing Jams

To clear jams from the printer:
Remove all damaged ribbon and/or media from the printer.
1.
Check that there is no damage to the print head, sensors, or any other parts.
2.
Check whether any cleaning is needed. If cleaning is required, see
3.
Reload ribbon and media and clear all error messages.
4.

Replacing/Adjust Media End Caps

In the unlikely even that your tape roll comes apart, contact Tech Support for assistance in
replacing or adjusting the end caps. See
Rev A
page 27).
page v for details.
39
Printer Maintenance
page 29 for details.
®
BBP 30 User's Manual