Table of Contents
Advertisement
The "RESET" button at the rear of the Cordless Base is not used.
Pressing the RESET button will make your Cordless Base
inoperable and require replacement.
Setting up the Cordless Handsets
4. Open Cordless Handset box and remove the Cordless
Handset, Power Clip, Power Adapter, and Charging Cradle.
Setting up the Cordless Handsets:
4. Open Cordless Handset box and remove the
Cordless Handset, Power Clip, Power Adapter, and
Charging Cradle.
5. Each Cordless Handset purchased from Intermedia will come
5. Remove the protective film from the Handset and
with batteries pre-installed. Batteries must be charged for 10
hours prior to first use. See instructions for installing batteries if
Charging Cradle.
not installed.
6. Remove the protective film from the Handset and charging
6. Insert the Power Clip into the Power Adapter (see
cradle.
Step 3).
7. Install the optional Belt Clip on the Cordless Handset
7. Connect the Power Adapter to the Charging Cradle in
the port shown.
15
8. Install the optional Belt Clip on the Cordless Handset.
For optimal battery performance, please charge the
phone for a minimum of 10 hours before using.
Once the phone has been plugged in and operational,
the voicemail box is functional with a default greeting.
are not used. Do not connect anything
Owner's Manual
The ports labeled "PHONE" and "LINE" at the rear of the Cordless
Base are not used. Do not connect anything to these connectors.
Note
Note: The ports labeled "PHONE" and
The "RESET" button at the rear of the Cordless Base is not used.
Pressing the RESET button will make your Cordless Base
"LINE" at the rear of the Cordless Base
inoperable and require replacement.
WARNING
Warning: The "RESET" button at the
rear of the Cordless Base is not used.
Pressing the RESET button will make
your Cordless Base inoperable and
Setting up the Cordless Handsets
4. Open Cordless Handset box and remove the Cordless
Handset, Power Clip, Power Adapter, and Charging Cradle.
8. Insert the power clip into the power adapter.
9. Insert the power adapter into the power source or wall outlet.
5. Each Cordless Handset purchased from Intermedia will come
10. Connect the power adapter to the charging cradle in the port
with batteries pre-installed. Batteries must be charged for 10
shown below.
hours prior to first use. See instructions for installing batteries if
not installed.
6. Remove the protective film from the Handset and charging
cradle.
7. Install the optional Belt Clip on the Cordless Handset
Only use the 1Amp power adapter designed for use with
Cisco Cordless Handset SPA300 Series devices.DO NOT
USE THE POWER ADPATER FOR THE CISCO CORDLESS
BASE
WARNING
11. Place the handset into the charging cradle. The light on the
charging cradle appears solid green when the handset is
charging.
Charge the Handset for a minimum of 10 hours before using the
Handset for the first time to ensure that the Handset is fully
charged
Note
12. After handset is fully charged or while the handset is in the
cradle do the following.
13. On the Cisco Cordless Handset, press and hold the End Call.
14. Release the End
seconds for the screen to illuminate.
to these ports.
require replacement.
15
button for 5 seconds.
Call button and wait up to 10
Owner's Manual
5
Owner's Manual
Advertisement
Table of Contents
