IBM thinkpad x30 Hardware Maintenance Manual page 54

Symptom-to-FRU index
Symptom or error
0189
Invalid RFID configuration
information area—The
EEPROM checksum is not
correct.
0190
Critical low-battery error
0191
System Security—Invalid
Remote Change requested.
0192
System Security—IBM
Embedded Security hardware
tamper detected.
0197
Invalid remote change
requested.
0199
System Security—IBM Security
password retry count exceeded.
01C8
More than one modem devices
are found. Remove one of
them. Press <Esc> to continue.
01C9
More than one Ethernet devices
are found. Remove one of
them. Press <Esc> to continue.
0200
Hard disk error—The hard disk
is not working.
021x
Keyboard error
0220
Monitor type error—Monitor
type does not match the one
specified in CMOS.
0230
Shadow RAM error—Shadow
RAM fails at offset nnnn.
50
ThinkPad X30 (MT 2672/2673)
FRU or action, in sequence
System board.
1. Charge the battery pack.
2. Battery pack.
1. Run IBM BIOS Setup
Utility, and then save
current setting by
pressing F10.
2. System board.
System board.
The remote configuration for
the security chip has failed.
Confirm the operation and try
again.
1. Run IBM BIOS Setup
Utility, and then save
current setting by
pressing F10.
2. System board.
1. Remove either a Mini PCI
modem card or an modem
daughter card; or press
Esc to ignore the warning
message.
2. System board.
1. Remove the Ethernet
device that you installed;
or press Esc to ignore the
warning message.
2. System board.
1. Reseat the hard-disk
drive.
2. Load Setup Defaults in IBM
BIOS Setup Utility.
3. Hard-disk drive.
4. System board.
Run interactive tests of the
keyboard and the auxiliary
input device.
Load Setup Defaults in IBM
BIOS Setup Utility.
System board.