Connecting To; Hardwiring; Stealth Hardwiring - Wheel Witness CMPRO Owner's Manual

Connecting to PC
Connect the USB Cable to the USB port and connect the other end of the USB cable to the USB port in
the PC. The red LED on the camera will turn on.
Press Power button on the camera – the screen on the camera will turn blue.
The computer now shows a removable drive which you can browse, just like a flash drive.
Alternatively, you can use the included memory card to USB adapter separately to view/copy the files
from the card.

Hardwiring

Depending on your vehicle and where your
cigarette lighter is located, you can choose to use
the included power adapter, or opt for our
"hardwire" stealth kit.
Some vehicles have a switched cigarette lighter
output, so if you connect it here, the camera always
turns on and off with the cars. Other vehicles, such
as older German cars have an always-on outlet, so
you either have to manually connect/disconnect
the camera or you can hardwire it.
The included power adapter is approximately 12
feet and can be routed around your windshield and
down the pillar, under you glove box and to the
cigarette lighter outlet for a clean install.
Stealth Hardwiring
If you would like a stealth install that you never have to worry about, we sell a hardwire kit. You can use
it to tap into your "Accessory" wire and the camera turns on and off with the vehicle. You never have to
remember to turn it on. Using a hardwire kit requires some basic technical skills. Depending on your
vehicle, you can route the wires to the back of your cigarette lighter or fuse panel. If wiring to a fuse
panel, please use a multi-meter or a test light to find a fuse that is ON when vehicle is in
Accessory/Ignition and is off when vehicle is off.
http://www.amazon.com/dp/B00TGQ1Y3Q/
Amazon: WheelWitness Hardwire Installation Kit
P a g e | 12